Pixel 60leds GS8208 DC12V Digital RGB LED-Strips

GS8208 12V Individual IC Chip
  The GS8208 is a 3-channel constant current constant LED drive with resumable data transfers and internal display patterns. There are data transfers and internal display patterns. There are three open-drain constant current outputs, with a build-in PWM of in grayscale. The range of input power is frgrayscale. The range of input power is frgrayscale. The range of input power is frgrayscale. The range of input power is frgrayscale. The range of input power is from +9V to 15V, and voltage-endurance of LED port is +12V

GS8208 led-strips has 3 advantage features:
 1.DC12V Individual Pixel, each pixel is addressabled
 2.Dual-Signal(one bad led,the signal still transfer)
 3.Built-in program effect,it can work without controller when power on it, but also can run as your own DIY programs with your controller system.

GS8208 LED-Strips Features
1.SMD5050 RGB Lighting Source
2.Working voltage: DC12V
3.Emitting color:Digital RGB
4.Gray Scale:256.
5.16.4 ft / 5m Reel,
6.Controlling Potocol:WS2811/UCS1903/GS8208
7.Viewing angle:120 degree,
8.Cuttable length: by every cutting mark(every led)
9.LED Qty :20/30/60 LED/m,
10.Pixels :20/30/60 per m,
11.White/Black PCB,White/Black Face LED,
12.IP20,IP65,IP67,IP68 for different options.

Product description
Long Life LED-strip GS8208 12V Digital RGB protected High Power distinguishes itself by the A-quality 5050 LED-chip that ensures an extra high light output. These LED-strips are fitted with the special GS8208 12V LEDs with an embedded controller chip that allows each LED to control color and brightness separately.

This does not require complex wiring plan, these LEDs are serially controlled by a specially designed microcontroller. With only three wires the strip can be controlled: Ground, +12 V (note the current!) And a serial data signal.

On the strip itself, between the LEDs this serial information is transfered from the serial output of one LED to the serial input of the next LED. It is thus possible for any length LED strip colors to come true at the beginning and end of each other, or even to create a display that  can display (moving) images. This digital LED-strip is perfect to control whith MaNima Interfaces.

Both RGB LED chips and the microcontroller are integrated in the housing SMD 5050, and together form a complete digital controllable full-color pixel. The LED has a built-in signal conditioning circuit to transfer the digital signal distortion free to the next LED input.

Built-in reset circuit and power lost reset circuit. Built-in electric reset circuit and power lost reset circuit. Each pixel of the three primary color can achieve 256 brightness levels (16.7 million color) full color display, and scan frequency not less than 400Hz/s.

Cascading port transmission signal by single line.

When the refresh rate is 30fps, low speed model cascade number are not less than 512 points, high speed mode not less than1024 points. Send data at speeds of 800Kbps. The color of the light were highly consistent.

Cost-effective applications.

Applications are for LED decorative lighting and indoor/outdoor LED video screen.

The LED used here is the GS8208, so 4-pin SMD 5050 package, for each color dual-chip thus exra high light output. Improvement of the light colors and a good white balance through gamma correction.